int servoPin = 2; // Control pin for servo motor

int minPulse = 500; // Minimum servo position
int maxPulse = 2500; // Maximum servo position
int pulse = 2500; // Amount to pulse the servo

long lastPulse = 0; // the time in milliseconds of the last pulse
int refreshTime = 20; // the time needed in between pulses

int analogValue = 0; // the value returned from the analog sensor
int analogPin = 0; // the analog pin that the sensor's on

void setup() {
pinMode(servoPin, OUTPUT); // Set servo pin as an output pin

pulse = minPulse; // Set the motor position value to the minimum

Serial.begin(9600);
}

void loop() {

analogValue = analogRead(analogPin); // read the analog input
Serial.println(analogValue);
// pulse = (analogValue * 19) / 10 + minPulse; // convert the analog value

if(analogValue >= 280 && analogValue < 350) {

pulse = 500;

}

if( analogValue <50){
pulse = 2500;

}

// pulse the servo again if rhe refresh time (20 ms) have passed:
if (millis() - lastPulse >= refreshTime) {

digitalWrite(servoPin, HIGH); // Turn the motor on
delayMicroseconds(pulse); // Length of the pulse sets the motor position
digitalWrite(servoPin, LOW); // Turn the motor off

lastPulse = millis(); // save the time of the last pulse
}

}