Breadboard view of an ArduinoNano connected to two force sensing resistors (FSRs) and a speaker. The Nano’s 3.3 Volts (physical pin 2) and ground (physical pin 14) are connected to the voltage and ground buses of the breadboard as usual. The FSRs are mounted below the Nano in the left center section of the breadboard. One leg of the first FSR is connected to voltage. The other leg is connected simultaneously to the first leg of the second FSR and the Arduino’s analog input pin A0. The second leg of the FSR is connected to ground. The red positive wire of the speaker is connected to digital pin 8 of the Arduino. The black ground wire of the speaker is connected to one leg of a 100 ohm resistor. The other leg of the resistor connects to ground.